CapStar Feeder

The CapStar cap feeder is designed and engineered to feed and orient flat screw caps, tamper evident caps and other minimal featured products at speeds ranging from 40 to 600 parts per minute.  Changeover from one cap to another takes less than five (5) minutes. The cleated elevator belt has a nominal cleat height of 2.00” and a cleat pitch of 4.00” allowing for maximum product loading. It is recommended that the cap diameter not exceed 3.50” with the standard belt, however, other belt sizes are available.

View Tech Sheet:  CapStar Feeder

Cap Sizes, Rates and Orientation:
Shibuya Hoppmann has tested different cap sizes and verified the corresponding rates and orientations. The results for you, however, may vary depending upon part material/construction, weight bias, and other uncontrolled factors.